Growing Technical Firm looking to hire an Electronics Assembler to their team. 

Job Duties

• Circuit card assembly assembly/rework including:
  • Population/de-population of fine-pitch surface mount parts, BGAs, and through-hole components
  • Isolation of components/circuits by lifted pins, cut traces, and kapton tape
  • Repair of cut traces, lifted pads
  • Addition of “floating” circuits to existing pads, exposed copper, and vias
  • Board clean-up and mechanical securement of all modifications
  • Conformal coating removal and touch-ups
  • Documenting all changes
• Cable assembly/rework including:
  • Initial assembly/build-up of cables per engineering drawings
  • Soldering, crimping, and termination of wires to connectors, lugs, or terminal blocks
  • Applying strain relief, potting, and isolation mechanisms in accordance with the drawings
  • Labeling the components
  • Performing continuity/resistance measurements, hi-pot tests
• General assembly tasks including:
  • Initial assembly of modules, enclosures, and rack system
  • Applying proper torque to fasteners
  • Use of adhesives, thermal pads
  • Cable management
  • Maintaining As-Built Lists
• Maintaining equipment necessary in the lab to perform tasks:
  • Reviewing drawings for necessary tools such as crimpers, press-fit pieces, etc. in advance of assembly
  • Identification and procurement of consumables such as IPA, conformal coating touch-up pens, flux, cotton swabs, solder tips, etc.
  • Tracking of equipment calibration, location, etc.
• Researching opportunities to improve the engineering team’s in-house capabilities and turnaround (e.g. re-work stations, etc.)
• Communication with the engineering team for alignment on goals and schedule
• Ability to put in extra hours when necessary to meet milestones